Module Specific Load Wiring (continued)
®
®
Installation Guide for CGP2730 Dimming and Switching Subplate 13
4-Circuit Switching Module (4R)
4-Output Motor Module (4M)
Neutral
Bus
Load
Terminals
Switched
hot/live
Hot/Live
Neutral
Load
Feed
Circuit breaker
Neutral
Neutral
Bus
Load
Terminals
Hot/Live
Feed
Circuit
breaker
N
L
H
R
L
R
Neutral
Neutral
Shade
L
R
L
R
Neutral
Raise
Lower
N
SH
H
SH
H
SH
H
SH
H
Neutral
Notice:
To avoid potential product damage, do not remove bypass jumpers until after load wiring has been verified.
• Connect Hot load wiring to the appropriate load terminal set for each circuit and Neutral to the Neutral bus.
•
corresponding to the terminal block numbers in the vertical terminal blocks located in the center of the panel
(as shown on previous page). These terminal blocks are where the bypass jumpers are installed.
• Output terminal blocks accept 14-10 AWG (2.5-4.0 mm
2
right of panel.
p
o
t
e
h
t
m
o
r
f
s
i
y
r
t
n
e
d
e
r
r
e
f
e
r
P
.
s
e
r
i
w
)
Load Circuit Wiring: 4R/4M (single typical dimming/switching leg shown for each module type)
Switched Hot (SH) or Raise/Lower (R/L)terminal blocks are grouped by a module (4 output circuits each)
in numbered order in the top right of the subplate. The numbers represent the sequential circuit in the panel,