31
Betty TL2 Pro
Deut
sc
h
Engli
sh
Check to ensure that the o-ring on the rear of the housing is correctly positioned. The
housing will only be waterproof if its o-ring is intact. After completing this check, carefully
screw down the housing cover.
Important!
The thread must always run smoothly, other-
wise, screw off the cover again immediately and try again.
The fine thread will not excuse
any mishandling - therefore, be extremely careful! Fully screw down the cover.
Cleaning:
Only clean the lamp when it is fully assembled. If required, use warm water and add some
mild dishwashing detergent.
Transport:
Caution!
Always separate the battery from the lamp!
Otherwise, the small amount of power used by the electronics will discharge the battery.
Furthermore, the lamp may be switched on accidentally. The uncontrolled heat buildup
could cause a fire or melt adjacent plastic material.
Storage:
When the lamp will not be used for a longer period of time, fully charge the battery and
leave it connected to the charger. Choose a cool, dry place for storage (basement etc.).
Note!
The lamp housing may be opened for installing an upgrade kit or a lens.
Open the lamp housing's front screw-on cover. Hold the rear of the lamp with one hand
while rotating the front cover to the left (counterclockwise) with the other hand.
Once you have removed the cover, you will see the 7-array lens.
Please avoid touching the lenses directly.
Opening the lamp housing:
Closing the lamp housing:
Product care and storage
