Lumi IML Connector, Руководство пользователя

Страница: 9 / 54

IML Connector
Page 9
5. Charging
This section describes the process for charging IML Connector devices using an IML Multidock or IML Minidock . Whilst there are
slight differences in the below instructions between the two dock devices, functionality remains the same.
›
IML Multidock
a) Remove the cover of the charging case.
b) If not already in the IML Multidock (i.e. ‘docked’), return the
IML Connector devices to the charging rack.
c) Connect the IEC power lead to the rear of the charging case.
d) Once powered, the fan built into the IML Multidock will start.
This is designed to circulate air around the IML Connector
devices and prevent overheating whilst charging.
e) The charging process will start straight after the initial boot
up phase of the IML Connector devices (taking approximately
30 seconds). The ‘traffic light’ colour coding on the device’s
status LED will then indicate the current level of battery
charge.
f) Once power is connected to the dock, the ON/OFF button on
the front can be used to cycle through different power states
(by pressing and holding). The colours of the two LED lights
next to the power button (i.e. the left-hand side of an IML
Multidock) indicate the power state of the dock (see the next
page for further details).
›
IML Minidock
An IML Minidock (pictured on the right) offers the same docking and
charging functionality as an IML Multidock, for 10 IML Connector
devices. IML Minidocks require a separate power supply unit and
cannot be powered with the same IEC power lead as an IML Multidock.
Always charge the IML Connector devices with
the case cover removed.
Important
Whilst charging, the status LED on the IML
Connector device will flash depending on its
current battery level…
Red 0 – 90%
Amber 91 – 99%
Green 100%
Reminder