Lumascape ZDClink, Руководство пользователя

Страница: 18 / 42

18
Operating the ZDClink Controller
Setting Up Programs
The Programs screen is where all daily running programs are
set up. Programs are set by scheduling luminaires that have
been assigned to groups or themes. For more about assigning
luminaires to groups, see “Assigning Luminaires into Groups" on
page 17.
1. Each program is designated by a letter (“A” through “G”) at
the top right section of the screen. Select the desired letter
using the scroll wheel prior to selecting the days of the week.
2. Selecting days of the week designates which days the
program will run based on the event settings. Select or
remove each day by highlighting the corresponding box over
each day with the scroll wheel and pushing to select
or deselect.
3. The Event field specifies the factors that will initiate a timed
event. Options include sunrise, sunset, or time.
4. The Time field specifies what time the programmed event
will occur. Sunrise/sunset times are based off of astronomical
timing set by the location (longitude and latitude) of the unit.
Optional timed offsets (± 15-minute increments) are available
for sunrise/sunset events. Time events are determined by
the time of day.
5. The Group/Theme field specifies which group or theme is
associated with each event. Scroll right to select groups.
Scroll left to select available themes.
6. The Color field specifies the desired color for group events.
Colors are not available for themes.
Figure 15: Programs screenshot
Note on Day Beginning and End
Days are designated to start and end at noon (12 p.m.).
This allows lights to continue running after midnight
within a single day’s program setting.
The % field specifies the desired intensity for each event.
Values range from 0% (off) to 100%. Theme events are limited to
On or Off.
You can create multiple events to initiate or change luminaire
intensities, but you must use a separate event to turn them off.