LUJAN USA SNIPER 5412a, Руководство пользователя, Страница: 7 / 32

Assembling the Aimer - Page 5
ASSEMBLY IS COMPLETE
The Sniper is factory calibrated for accuracy, to verify calibration of aimer, see section on
aimer calibration.
fig. 6
Hardware for Pointer
Positioning System
Attach the holder to the middle of
the aimer head, at the tip of the
pointer.
fig. 8
STEP 4
Install the lateral alignment visor (fig. 5). The
narrow slot in the visor should face the rear of the
aimer (the wide slot faces the front).
STEP 5
Install the pointer positioning system using hardware
as shown in figure 7. Hardware is attached to the
optical aimer head and must be removed for pointer
installation, see figure 6.
Thread nut on bolt , insert
through eye in pointer system and
thread nut
on bolt . Install
assembly on optical aimer head
tightening nut
against aimer as
shown in fig. 7.
Repeat the process for stopper pin.
B A
C A
C
fig. 7
C B
A
pointer system