Lucent Technologies Galaxy Power System 4804AP H569-450
12 - 4 Maintenance and Replacement
Issue 1 June 2000
Replacement Procedures, continued
Installing or Replacing a Rectifier, continued
Step
Action
5
Slowly slide new rectifier onto the shelf until it contacts the
rear connector.
6
Using the Allen wrench, turn the Allen-head bolt clockwise
to pull the rectifier into the shelf.
7
Once the rectifier has been installed, set the rectifier ID.
Follow the directions for the “ID Not Configured” alarm in
Table 14-E (Millennium) or “rid” in Table 15-E (Vector).
Note: The red LED on the rectifier will blink until the
rectifier establishes communication with the controller.
After communication is established, the controller will issue
a RECT MAJ alarm until the rectifier ID is set.
8
Turn the ac service back on.
9
Turn the rectifier’s ON/STBY switch to ON.
