Lucent Technologies CAJUN P120, Руководство пользователя

Страница: 48 / 130

Chapter 6 Legacy CLI (Command Line Interface)
34 Cajun P120 User’s Guide
You may now set the SLIP address of the management station. Either:
• Keep the default setting by pressing Enter, or
• Type a new value and press Enter. For example, to change the IP address,
enter:
194.90.120.115
The next parameter displays automatically.
>Group: snmp - Configuration of SNMP community names and trap
managers.
setup> community 1 [community public r]?
Note:
If you would like the SNMP traps to display in the OpenView Alarm Log,
you should set the IP address and net mask of the OpenView station under trap
manager (community 1 trap).
You are now going to configure the SNMP group. The first parameter is the SNMP
community name. Its default setting is public read-only.
You may now set an SNMP community name. Either:
• Keep the default setting by pressing Enter, or
• Type a new value and press Enter. For example, to change the community
name, enter:
newname r
The
r
parameter defines the community as read only; the
rw
parameter defines it as
read/write.
Continue with the other four community names until you come to the following
prompt:
setup> community 1 trap [0.0.0.0]?
You may now set the IP address of a management station to receive traps. Either:
• Keep the default setting by pressing Enter, or
• Type a new value and press Enter. For example, to change the IP address,
enter:
194.90.121.233
. (If you are running CajunView in conjunction with
HP OpenView, you should enter the IP address of the OpenView station here
for it to receive traps from the Cajun P120.)
Continue until you come to the following prompt:
Save the new configuration (y/n)?
Either:
• Enter
y
to save your configuration and write it to the flash memory.
• Enter
n
to discard this configuration.
If you wish to make any corrections or modifications, either exit the Privileged level
and re-run the simple-setup command, or use the set command to set a particular
group/parameter. (Be sure to use the write command to save your changes.)
Wait 15 seconds for confirmation of the write process.