Lucent Technologies CAJUN P120, Руководство пользователя

Страница: 40 / 130

Chapter 5 Introduction to the Command Line Interfaces
26 Cajun P120 User’s Guide
Establishing a Telnet Session (Ethernet port or modem)
Follow these instructions to establish a Telnet session (remote connection) and
then use the internal CLI to configure the switch.
1 Verify that the Cajun P120 and your PC are on the same local network. If the
Cajun P120 is set with its default IP address, then change your PC’s IP address
so that it will be on the same IP subnet as the Cajun P120’s default address. The
port to which the PC is connected must be on the same VLAN as the agent.
Note:
i) If you establish a serial connection to the Cajun P120, you will not have to
change your station’s IP address.
ii) The Cajun P120 default IP address is 149.49.32.134 and subnet mask is
255.255.255.0.
2 Click
Start Settings Control Panel Network
from the Windows
task bar.
3 Select
TCP/IP
from the list of installed network components.
4 Click
Properties
.
5 In the
IP Address
property sheet, enter the address
149.49.32.134
and
net mask
255.255.255.0
.
6 Click
OK
.
7 Connect a shared port or switched port on the Cajun P120 switch front panel to
your network.
8 Connect your PC to the network.
9 At the prompt, start the Telnet session by typing:
telnet <Cajun_P120_IP_address>
For example,
telnet 149.49.32.134
Note:
If there is a serial connection to the Cajun P120, the Telnet session will
terminate the serial session.
10 Enter the default password
norm
in lower case letters (do NOT use uppercase).
The
CajunP120>
prompt will display when you have established
communications with the Cajun P120.
11 You can now configure the Cajun P120 and change its default IP address. See
the Section “Navigation, Cursor Movement and Shortcuts” below.
12 If you changed your PC’s IP address, you must return it to its original address.
13 Insert the Cajun P120 into your network and ping to verify that there are
proper Ethernet communications.