Lucent Technologies 4ESS SCS, Руководство по обслуживанию

Страница: 462 / 526

234-151-077AC DLP-557
1999 June 7, Issue 5 of 4 Page
cabinet. the from removed was that CDSU-II the from cover top the Remove 10.
old the from cards AYC53 and AYC52, BYC51, the move to steps following the Complete 11.
CDSU-II. new the to CDSU-II
AYC52, BYC51, the to connected cables ribbon the disconnect CDSU-II, old the At A.
removed. be to cards AYC53 and
AYC52, BYC51, each from screw holding the remove time, a at One WARNING. See B.
same the in card the install and card, the remove and up lift card, AYC53 and
CDSU-II. new the in location
holding the replace and position, into seated fully is card new each that Ensure
card. each of back the at screw
be must clip the and worn be always must strap wrist A WARNING:
any removing or inserting before on worked being unit the to grounded
CDSU-II. the from cards
AYC53 and AYC52, BYC51, the to cables ribbon the connect CDSU-II, new the At C.
CDSU-II. old the in from removed were they positions same the in cards
CDSU-II. new the to cover top the Attach 12.
that recommended is (It position. into locks it until cabinet the into CDSU-II new the Slide 13.
function.) this perform people two
was that pin the re-inserting by CDSU-II the of rear the at arm cable the Reconnect 14.
6. Step in removed
cabinet. the into way the of rest the CDSU-II the Slide 15.
3. Step in removed were that cable) LAN the of exception the (with cables the Reconnect 16.
later. reconnected be will cable LAN The
Proprietary — Technologies Lucent
instructions Company to pursuant Use