Lucent Technologies 4ESS SCS, Руководство по обслуживанию

Страница: 443 / 526

DLP-552 234-151-077AC
8 of 1 Page 1999 June 7, Issue
Copy Disk Inter-SCU
Summary: an though even However, copy. disk inter-SCU an perform to used is procedure This
this In SCU. another to SCU one from directly not is copy the done, being is copy disk inter-SCU
manually is SCU) "source" the as to (referred SCU one with associated disk good a procedure,
"destination" the as to (referred SCU another at inserted and SCU source the from removed
an perform to used then is SCU destination the at inserted was that disk good This SCU). intra-
SCU to returned then is disk good original The SCU. destination the update to order in copy disk
the between announcements copy to used be only should procedure This SCU. source the
pairs. disk type same
the of location the determine Cabinet), (SCU 2 Figure and/or Cabinet) (SCC 1 Figure Using 1.
pair(s). disk associated their and SCUs source/destination
the toggling by service from SCU destination the remove SCUs, destination the At 2. ROS
from pack circuit TN1984 the on switch NORMAL to ROS the When . OS on, goes lamp
entering by SCU the with associated pair disk the on 1) (TYP Initialization Soft a perform
terminal: MTC 1B the at messages following the
A. INIT:SCS a,SCU b,DSK c 1! 0,TYP ,BUS
where a (0-7) Number SCS =
b (0-15) Number SCU =
c (0-1) Number Pair Disk SCU =
Response:
INIT:SCS
a
,SCU
b
COMPLETE
B. INIT:SCS a,SCU b,DSK c 1! 1,TYP ,BUS
where a (0-7) Number SCS =
b (0-15) Number SCU =
c (0-1) Number Pair Disk SCU =
Response:
INIT:SCS
a
,SCU
b
COMPLETE
Note: packs, circuit TN4000 of up made is SCU the with associated pair disk the If
the in disk each for (once twice input be to needs commands above the of each
location, 0 pair disk a at example, For required. is INITs four of total a Thus, TN4000).
combinations: following the for required are INITs
•
0 BUS 0, DSK
•
1 BUS 0, DSK
•
0 BUS 1, DSK
•
1 BUS 1, DSK
Proprietary — Technologies Lucent
instructions Company to pursuant Use