Lucent Technologies 4ESS SCS, Руководство по обслуживанию

Страница: 418 / 526

234-151-077AC DLP-542
1999 June 7, Issue 3 of 2 Page
of CDSUs the connecting cable coaxial LAN the disconnect HUB, Smart defective the At 7.
connector same the to cable this Connect service. from removed just was that SCU the
HUB. Smart new the on position
entering: by reconnected just was that SCU the diagnose terminal, MTC 1B the At 8.
DGN:SCS
a,SCU b
17! :PH
where
a
(0-7) number member SCS =
b
(0-15) number SCU =
with message output an returns screen The Response:
ATP
.
pass? 8 Step in diagnostic the Did 9.
If YES 10. Step to continue ,
If NO 8. Step to return and connections cable coaxial the check then ,
terminal: MTC 1B the at message input following the entering by SCU the Restore 10.
RST:SCS a,SCU b!
where a (0-7) number Member =
b (0-15) number Submember =
Response:
RST:SCS
a
SCU ,
b
COMPL
lowest- next the with beginning SCU, ASR-equipped each for 10 through 6 Steps Repeat 11.
SCU. numbered
has HUB Smart defective the When 12. no volt 110 remove it, to connected cables coaxial
HUB. Smart defective the from power
disturb to not careful being CDSC, the from HUB Smart defective the remove Physically 13.
HUB. Smart new the at connections coaxial the
to not careful being CDSC, the in properly HUB Smart replacement new the Position 14.
connections. coaxial the disturb
Note: and another one contact not must T-connector and connectors coaxial The
isolated.) electrically is LAN (Each ground. frame contact not must
Proprietary — Technologies Lucent
instructions Company to pursuant Use