4.1 Lockout and tagout
4 Electrical safety checklist
All installation, controls, service, repair, and maintenance employees must have this list with them at every job
and read it through before starting the job.
Note:
These are the minimum requirements. If you do not meet these requirements, do not start the
work.
4.1 Lockout and tagout
Proceed as follows:
1.
Notify affected persons of the shutdown.
2.
Shut down the equipment.
3.
Disconnect, lock and tag all energy sources.
4.
Release any stored energy (capacitors, transformers, etc.).
5.
Ensure that all employees working on the equipment have their personal locks in place.
6.
Prior to servicing the equipment, ensure with a ”proximate voltage sensor” that the frames or control
enclosures of the equipment are not energized.
7.
Check that the circuit-testing devices function.
8.
Verify the absence of electrical current or voltage with a circuit-testing device.
Use insulated gloves and an insulated mat.
©
Alfa LU-VE, Rev-04
15
Alfa LU-VE is a trademark registered and owned by LU-VE Group.
Alfa LU-VE reserves the right to change specifications without prior notification.
