LSIS XBL-EIMT, Руководство пользователя, Страница: 36 / 164

Chapter 3 Installation and Test Operation
3-8
3.3.2 RAPIEnet I/F module for PC
Note
1) After setting station number, make sure to turn power on or reset the PC I/F card. The value read from the PC
I/F card at the first time setting of station No. is maintained. Change of station No. during communication is not
applied in the current operation.
Begin
Install I/F card for PC in an empty PCI slot.
→ The slot should be free from interference from other PC cards.
Set the station No. of the I/F card for PC.
→ If the station No. is same with other RAPIEnet I/F Module on the network, conflict
will occur.
Connect the PC I/F card with another network.
→ Construct the system using jig appropriate for the medium.
Turn power on. Check the LED of the PC I/F.
→ Check that the „P‟(Power) and „S‟(Status) LED on the PC I?F card are lit.
Install device driver.
→ PC I/F card cannot be used without device driver.
Carry out programming using the DLL and Lib which are provided.
→ Programming should be made out with the DLL and Lib suitable for desired
functions.
Set the high speed link of the RAPIEnet I/F communication module.
→ Execute the service to enable communication of the RAPIEnet I/F communication
module with the PC I/D card.