LS tractor MT2 25S, Руководство оператора

Страница: 103 / 187

4 - 23
①
Drawbar

It is used to tow the equipment having 2 axles.

It is available to adjust the length of the draw bar
after removing snap pin and lock-pin in the right
figure. After adjusting the length, assemble the
pins correctly.

Insert the hitch pin and snap pin correctly after
attaching/detaching the equipment.

Vertical load : 300kg (661lb) – Regular position.
(Extend position is not available.)

Horizontal load : 1000kg (2204 lb)
Drawbar
Snap pin
Lock pin
▶
Use always the drawbar or hitch for pulling work. DO NOT use the 3-point linkage,
rear axle or other parts. If so, the tractor could be overturned.
▶
When attaching/detaching towed equipment, apply the parking brake and stop the
engine before applying the locking pins manually.
▶
Before transporting equipment on public roads, make sure you comply with your
local traffic regulation.
Caution
Drawbar
Unbraked towable mass N/A
Inertia-braked towable mass 1000kg (2204 lb)
Hydraulic & Pneumatic braked towable mass N/A
②
Technically permissible maximum towable mass(es)

The maximum permissible towable mass is depending on the brake system type on the towed
equipment as below. Check the brake system of your towed equipment.
(3) Hitch and Drawbar (optional)

When attaching towed equipment, use the hitch
or drawbar. DO NOT use the 3-point linkage or
other parts. If so, the tractor could be overturned.

When attaching/detaching towed equipment, be
sure to check the pins locked in place correctly.

DO NOT exceed the maximum permissible
vertical and horizontal load of the coupling.