LS tractor MT2 25S, Руководство оператора

Страница: 146 / 187

5 - 31
(4) Replacing Air cleaner element
(Dry type)

Remove the cover and pull out the primary filter
element straight out.

Clean the inside of the air cleaner housing using
a clean damp cloth.

Check if there is damage inside the filter element
by using a light. If finding a tiny crack or small
hole in the filter element or the gasket is
damaged, replace it with a new one.

Insert the filter element deeply into the filter
housing.

Remove the dust of the evacuator valve and
clean the inside of the cover.

Assemble the cover with the evacuator valve
facing downwards.
▶
Do not start the engine or close the hood if the filter element is not assembled..
Notice
Adjusting plate
Bolts
Crank shaft
pulley
Alternator
(3) Tension adjustment of Fan belt

If the fan belt tension exceeds the normal
value, adjust the tension as below.
- Belt tension: crank shaft pulley ~ alternator
pulley
- Normal: approx. 10~12mm (0.4~0.5 in.)
(When pressed by 98N (22 lb))

When adjusting the belt tension,
1. Loosen two bolts of alternator and a hinge bolt
of adjusting plate slightly.
2. Insert a bar between crank case and alternator,
and pull the bar to apply tension to the belt.
3. With proper tension, tighten the upper bolt of the
alternator.
4. If the fan belt tension is normal, tighten the other
bolts.

Check the condition of fan belt for of cracking or
fraying. If wear is indicated, replace it with a new
one.
Check point
Cover
Primary filter
element
Evacuator
valve