LS tractor MT2 25S, Руководство оператора

Страница: 149 / 187

5 - 34
5-8. Every 500 hour check
(1) Changing Front axle oil

Stop tractor on a level surface and apply parking
brake. Clean around oil filling inlet and drain
plugs.

Set a clean container under the drain plugs and
Remove both LH and RH drain plugs and oil
gauge to drain the oil completely.

Assemble the drain plugs with new seals.

Add new oil into the oil filling inlet with checking
if the oil level is between “MIN” and “MAX”
marks of the oil gauge.

After 5~10 minutes later, recheck the oil level
and tighten the oil gauge.

For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
Drain plugs
Oil filling inlet
& Oil gauge
▶
Contaminated oil may reduce
the durability of the
transmission and it can cause a
failure of the hydraulic system.
Clean around the oil filling inlet
and then pull the oil gauge.
Caution
(2) Changing Transmission oil

Stop tractor on a level surface and apply parking
brake. Run engine for several minutes to warm
oil and lower implements and stop the engine.

Clean around the oil filling inlet and drain plug(s).

Set a clean container under the drain plug(s) and
remove the drain plug(s) under the transmission
and drain the oil completely.

Clean metal chips and sludge stuck to the drain
plug(s) and tighten the drain plug(s) again with
new seal(s).

Add new oil until the oil level is between “Min”
and “Max” marks of the oil gauge.

For oil specification, see chapter 5-3, “Lubricants
and Capacity” or the last page in this manual.
Drain plugs
Oil filling inlet
Oil gauge