TIWI TRANSCEIVER MODULES
USER’S GUIDE
The information in this document is subject to change without notice.
Confirm the data is current by downloading the latest revision from www.lsr.com.
LSEVK-WP-01-A2-UG
Copyright © 2010 LS Research, LLC
Page 34 of 35
IMPORTANT NOTE:
In the event that these conditions cannot be met (for certain
configurations or co-location with another transmitter), then the FCC and Industry
Canada authorizations are no longer considered valid and the FCC ID and IC
Certification Number cannot be used on the final product. In these circumstances,
the OEM integrator will be responsible for re-evaluating the end product (including
the transmitter) and obtaining a separate FCC and Industry Canada authorization.
End Product Labeling
The TiWi-R1Module is labeled with its own FCC ID and IC Certification Number. If the FCC ID and
IC Certification Number are not visible when the module is installed inside another device, then
the outside of the device into which the module is installed must also display a label referring to
the enclosed module. In that case, the final end product must be labeled in a visible area with
the following:
“Contains Transmitter Module FCC ID: TFB-TWI1-01”
“Contains Transmitter Module IC: 5969A-TIWI101”
or
“Contains FCC ID: TFB-TIWI1-01”
“Contains IC: 5969A-TIWI101”
The OEM of the
TiWi-R1
Module must only use the approved antenna(s) listed above, which
have been certified with this module.
The OEM integrator has to be aware not to provide information to the end user regarding
how to install or remove this RF module or change RF related parameters in the user
manual of the end product.
The user manual for the end product must include the following information in a
prominent location:
“To comply with FCC and Industry Canada RF radiation exposure limits for general
population, the antenna(s) used for this transmitter must be installed such that a minimum
separation distance of 20cm is maintained between the radiator (antenna) and all
persons at all times and must not be co-located or operating in conjunction with any
other antenna or transmitter.”