TIWI TRANSCEIVER MODULES
USER’S GUIDE
The information in this document is subject to change without notice.
Confirm the data is current by downloading the latest revision from www.lsr.com.
LSEVK-WP-01-A2-UG
Copyright © 2010 LS Research, LLC
Page 33 of 35
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause
undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
INDUSTRY CANADA STATEMENTS
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more
than that permitted for successful communication.
This device has been designed to operate with the antennas listed in Section 3.2, and
having a maximum gain of
4.3 and -0.6
dB. Antennas not included in this list or having a
gain greater than
4.3 and 0.6
dB are strictly prohibited for use with this device. The
required antenna impedance is
50
ohms.
OEM Responsibilities to comply with FCC and Industry Canada Regulations
The TiWi-R1 Module has been certified for integration into products only by OEM integrators
under the following conditions:
1. The antenna(s) must be installed such that a minimum separation distance of 20cm
is maintained between the radiator (antenna) and all persons at all times.
2. The transmitter module must not be co-located or operating in conjunction with any
other antenna or transmitter.
As long as the two conditions above are met, further transmitter testing will not be
required. However, the OEM integrator is still responsible for testing their end-product for
any additional compliance requirements required with this module installed (for example,
digital device emissions, PC peripheral requirements, etc.).