XDesignerPlus Ver2.0 Communication Manual
12 / 13
OK!
Communication setting succeeded
Time Out Error!
Communication setting error
- Error in the setting situation of Cable and TOP / External device
(reference : Communication Diagnosis sheet)
Details
Contents
Confirm
TOP
Version Information
xDesignerPlus :
O.S :
Name of Driver
OK
NG
External device
information
IP Address
OK
NG
(xDesignerPlus
Subnet mask
OK
NG
Project setting)
Gateway
OK
NG
TOP Information
Protocol
UDP/IP
TCP/IP
OK
NG
(Main
Device
Menu Setting)
IP Address
OK
NG
Subnet mask
OK
NG
Gateway
OK
NG
Other specified setting info
OK
NG
System
configuration
System Connection Method
1:1
1:N
N:1
OK
NG
Name of cable (Hub usage)
Direct (Use Hub)
Cross (No Hub)
OK
NG
External
device
Name of CPU
OK
NG
Name of communication device
OK
NG
Protocol(mode)
OK
NG
Other specified setting info
OK
NG
IP Address
(Local)
(Destination)
OK
NG
Port number
(Local)
(Destination)
OK
NG
Subnet mask
OK
NG
Gateway
OK
NG
Address range confirm (other docs)
OK
NG
4.3 Communication diagnosis
■ TOP - Confirming interface setting condition between external devices
- Move to Menu by clicking the top side of LCD screen as resetting the power of TOP.
- [Main Menu >Communication setting] Confirm if detail in number 20~24 is identical to the setup information of “■Setup exercise
1”.
- PLC Setup > Click the button in "
Communication diagnosi
s" of TOP Ethernet.
- Diagnosis dialog box will pop up on the screen, you can judge by following informations that are shown on box no. 3 section.
■ Communication Diagnosis Sheet
- Please refer to the information below if you have a problem between external devices and communication connection.
