LPKF ProtoMat 93s Manual
30
19. When the drill phase is complete, mill phase
MillingCompSide
is selected
after any through-plating.
20. The milling depth should now be set. To do this, click
1Unimill
in the tool
combo box. The head travels to the tool change position. Insert the universal
milling cutter and, with the arrow keys, move over the base material, but not
over the project, in BoardMaster.
21. Set the step size using
Machine Settings..
to some small step (0.1 inch or 0.2
mm). Go into mill mode, switch on the motor, lower the head and move with
the arrow keys. Set the milling depth. See too the section entitled "How the
mechanical working depth limiter works".
22. The mill data for the component side is now selected with
ALL+.
Machining is
started with
Start
.
23. If all of the top or component side operations are finished, then move to the
pause position and turn the material.
24. Select and carry out the
MillingSoldSide
mill phase.
25. If required, select the
Cutting
mill phase and machine with a contour milling
cutter.
26. Move to the pause position, remove the PCB and proceed as described in the
section entitled "Cleaning the PCB".
