Lowrance HDS Gen3 Polaris, Руководство по установке

Страница: 25 / 44

| 23
Software setup | HDS Gen3 Polaris Installation Manual
Rx and Tx errors are most likely indicating issues with the physical
network, which may be resolved by correcting termination, reducing
backbone or drop lengths, or reducing the number of network
nodes (devices).
Damping
If data appears erratic or changes too rapidly, damping may be
applied to make the information appear more stable. With damping
set at MIN, the data is presented in raw form with no damping
applied. This is available for speed over ground, course over ground,
and heading.
NMEA 0183 setup
The NMEA 0183 port must be set to suit the speed of connected
devices, and can be configured to output only the sentences
required by listening devices.
Receive waypoint
Select this option to allow a device
capable of creating and exporting
waypoints via NMEA 0183 to
transfer directly to the HDS Gen3
Polaris.
Baud rate
This should be set
to correspond with
devices connected to
the NMEA 0183 input
and output. The input
and output (Tx, Rx)
use the same baud
rate setting.
Serial Output
Selection will determine whether the data is output via Tx lines, and
will enable editing of the output sentences list.