Lowrance HDS Gen3 Polaris, Руководство по установке, Страница: 31 / 44

| 29
Software setup | HDS Gen3 Polaris Installation Manual
Channel
Channel setting is available in order to
overcome potential interference to the
GoFree device by another RF device
transmitting in the same frequency band.
Client settings
Displays information about the wireless
hotspot your unit is connected to or the last
one your unit was connected to. You can
select the hotspot in the dialog to set it as a hotspot you want to
always connect to when in range or you can select to delete it.
Advanced
Tools are available within the HDS Gen3 Polaris software to assist in
fault-finding and setting up the wifi network.
Iperf
Iperf is a commonly used network performance tool. It’s provided
for testing wireless network performance around the vehicle so
weak spots or problem areas can be identified. The application must
be installed on and run from the tablet device. The HDS must be
running Iperf server before initiating the test from the tablet. On
exiting the page, Iperf will automatically stop running.
DHCP Probe
The wireless module contains a DHCP server that will allocate IP
addresses for all the MFDs in a network. If integrating with other
devices, such as a 3G modem or satellite phone, other devices in the
network may also be acting as DHCP servers. To make it easy to find
all DHCP servers on a network, dhcp_probe may be run from the
HDS.
Only one DHCP device may be operational on the same network
at a time. If a second device is found, turn off its DHCP feature if
possible. Refer to the device’s own instructions for further assistance.
¼
Note:
Iperf and DHCP Probe are tools provided for diagnostic
purposes by users familiar with network terminology and
configuration. Navico is not the original developer of these tools,
and can not provide support related to their use.