Lowrance HDS Gen3 Polaris, Руководство по установке

Страница: 26 / 44

24 |
Software setup | HDS Gen3 Polaris Installation Manual
Serial Output Sentences
This list allows control over which sentences need to be transmit
to other devices from the NMEA 0183 port. Due to the limited
bandwidth of NMEA 0183 it is desirable to only enable the data that
is required. The less sentences are selected, the higher the output
rate of the enabled sentences.
Commonly used sentences are enabled by default.
NMEA 0183 over Ethernet
The NMEA 0183 data stream is also output over ethernet, which is
made available to tablet devices and PCs, using the WIFI-1 wireless
adaptor.
The
Ethernet
dialogue provides IP and port data typically required
for configuring the application on the third party device.
¼
Note: Other MFDs cannot decode this information back to NMEA
0183, to use the data as a source. To share data a physical NMEA
2000 or NMEA 0183 connection is still required.
Ethernet setup
No special setup is required for establishing an ethernet network,
it is all ‘plug and play’ . An optional NEP-2 connected between the
HDS Gen3 Polaris and another network module will automatically
start working, and relay data between the two devices.
Diagnostics
The UDB (User Data Base) tab on the diagnostics page, provides
information on Ethernet activity, as shown below.