ENG
LISH
12
12
INSTALLING THE HOPPER
Step 4 Attaching the Hopper to the Cabinet:
Carefully slide the entire hopper with the attached grill probe
wires into the hopper cut out area of the cabinet.
See
Diagram
Begin by slightly inserting the Auger Feed tube into the
correct hole. Then slide hopper fully into location.
The hopper should be tight against the inside cabinet
wall.
Holding the hopper in place, use one (1) of the Multi-head
screws (AA), from the six (6) you put in the cavity, and
begin hand threading it into one (1) of the six (6) holes
provided in the upper cabinet cavity.
NOTE: If the holes do not line up, the hopper may
need to be fully pushed into place.
Now with the hopper partially secured, hand starting the
remaining five (5) screws (AA). When complete use a
Phillips screwdriver to secure.
NOTE: Taking extra care not to strip the screw heads
will aid in the future.
Assembly Instruction
INSTALLING THE IGNITER ASSEMBLY:
A
B
Parts Needed:
Tools Required:
Installation:
The Igniter assembly has been connected to the wire harness at the factory and
can be found in the hopper electrical housing.
Reach in through the burn pot and carefully pull the igniter assembly forward
into the burn pot area. Diagram A
Line up the two holes on the igniter bracket over top of the two holes found
in the bottom of the burn pot. Diagram A & B
Using your Phillips screw driver and the two (2) Multi-head screws (AA)
secure the igniter assembly to the burn pot. Diagram B
2 x Screws (AA)
1 x Igniter Assembly
(located in hopper)
Phillips Screw Driver
or
Cordless Drill &
Phillips driver