20
1. General information
1.1. Manual use
Before undertaking any equipment assembly or maintenance operation on the air filter carefully read the instructions
provided in this manual.
1.1.2. Typographic information
Note
The word "NOTE", on the left side of the page, signals important information
Warning!
The word "WARNING", on the left side of the page, indicates those procedures for which the partial or
total failure to comply may cause damages to the air filter unit or to the machine tool connected to it.
Danger!
The word "DANGER", on the left side of the page, indicates those procedures for which the total or
partial failure to comply may cause injury to the operator.
1.2. Warranty
1. General conditions
Losma S.p.A. (hereinafter known as
Supplier
) undertakes to deliver to the purchaser products conforming to the agreement
which are exempt from defects such as to make them unsuitable for the use to which products of the same type are
employed and guarantees the products sold for 365 days from the date of delivery with an hourly limit of use equal to 2000
hours.
The guarantee ex-
Supplier’s
works is limited to the replacement or repair of the products which, in the unquestionable
opinion of the
Supplier,
are defective.
Components not directly constructed by the
Supplier
will be the subject of a guarantee according to the conditions used by
his supplier to the
Supplier
.
It remains understood that all the components replaced shall be the property of the
Supplier
or his supplier.
2. Notification of non-conformity to guarantee or defective product
The notification of non-conformity or defect of the product must be communicated in writing to the
Supplier
with a clear
indication of its nature within 15 days of the date it was found or could have been found following a thorough examination of
the product. In addition, the purchaser, against
Supplier’s
request, must place at the disposal of the
Supplier
, the product
deemed non conforming and/or allow people assigned by the
Supplier
to carry out all the checks that the
Supplier
deems
suitable in order to ascertain the effective non conformity or defect of the product.
The lack of communication of the potential non-conformity or fault of the product in the times indicated and/or if the latter is
not made available shall cause the immediate termination of the guarantee. The purchaser also forfeits the guarantee if, the
supplier has requested the faulty piece to be returned at his expense and the purchaser omits to return such piece within a
short period of the request.
The regulations of articles 40 and 44 of the Vienna Convention shall not be applicable in any case.
3. Repairs or replacements
The
Supplier
shall fulfill the obligations set out in the guarantee by repairing or replacing the non-conforming or defective
parts. In order to fulfil the guarantee the
Supplier
can choose:
to carry out the repairs at his factory: in this case the purchaser is obliged to send at his expense, the products to
the factory indicated by the
Supplier
and to collect them ex-factory, after the execution of the guarantee.
to carry out or have carried out by third parties the repairs and/or replacements in the place where the products are
located. In this case the travelling costs, board and lodgings shall be at the expense of the purchaser;
to have the repair and/or replacement carried out by the purchaser supplying the relative instructions and possibly
supplying free of charge, ex the
Supplier’s
factory or reimbursement of the spare parts.
The guarantee for the pieces replaced or repaired terminates on the same day as the guarantee of the product.
4. Exclusions
The
Supplier
shall not be held liable for defects or faults pertaining to the product which are directly or indirectly attributable
to information, data, projects, materials and to any other tangible or intangible good supplied, indicated or requested by the
purchaser or by third parties acting in whatever role, in the name and on behalf of the latter.
Not covered by this guarantee are all the defects directly or indirectly attributable to incorrect, excessive or improper use of
the equipment and including all the times the equipment is used in a manner different from that described in the technical
EN
