55
11 MANUFAC-
TURER’S
WARRANTY
HR-xx Pumps, ECDRIVES and PS-xxx
controllers are warranted by the manufac-
turer to be free from defects in material
and workmanship for two (2) years from
date of purchase.
Failure to provide correct installation, opera-
tion, or care for the product, in accordance
with the instruction manual, will void the
warranty. Product liability, except where
mandated by law, is limited to repair or
replacement, at the discretion of the manu-
facturer or importer.
Neither manufacturer nor importer is respon-
sible for the labor or other charges necessi-
tated by the removal, transportation, or
reinstallation of any defective product.
Warranty does not cover damage due to
failure to install the device properly, mishan-
dling or abuse, failure to protect circuitry from
weather exposure, failure to protect from
overheating due to sun exposure or other
sources of heat, failure to protect from salt
spray or other corrosive factors such as
electrolytic action, failure to seal out insects,
spiders or rodents, lightning, flood or other
acts of nature, or failure of or inappropriate
application of peripheral devices including
lightning or surge protectors.
Pump Rotor / Stator and Vanes of PS-Boost,
ETAPUMP and PS-XXX Motor / Pump are
considered to be normal wearing parts, and
are not covere under warranty.
Warranty does not cover damage due to
sand or abrasive particles in the water, or
incompatibility of pump materials with
corrosive substances or hydrocarbon or
petroleum impurities, or from running the
pump with an insufficient supply of water.
No specific claim of merchantability shall be
assumed or implied beyond what is printed on
the manufacturer’s or importer’s printed
literature. No liability shall exist from circum-
stances arising from the inability to use the
product, or its inappropriateness for any
specific purpose. It is the user’s responsibility
to determine the suitability of the product for
any particular use.
12 STANDARDS,
ENVIRONMENTAL
AND TEMPERA-
TURE SPECIFI-
CATIONS
In all cases, it shall be the responsibility of
the customer to ensure a safe installation in
compliance with local, state and national
electrical codes.
PS-xxx
controllers are built to DIN-VDE
regulations and carry the CE stamp indicat-
ing that the European Union electromagnetic
interference standards (Dt. EMV) have been
fulfilled. Printed circuit boards are conformal-
coated against moisture. The enclosure is
thick anodized aluminum, gasket-sealed and
raintight for any outdoor environment (enclo-
sure class IP55). The controller is suited to
tropical conditions according to IEC 68-2-30.
The controller is not submersible.
Temperature Ranges
Pumps:
Helical rotor pumps (all without C in
the model number): For pumps in the stand-
ard temperature class, the optimum range of
water temperature is 46°F to 72°F (8°C to
22°C).
Controller:
Ambient air temperature -22°F to
113°F (-30°C to 45°C). The controller has
over-temperature protection.
Storage Temperature
Pump and controller can be stored (not used)
in the range of 0°F to 120°F (-20° C to 50 °C).
