3DM-GX5-45
™
GNSS-Aided Inertial Navigation System
DCP Manual
4.1.6
Resume (0x01, 0x06)
Description
Place device back into the mode it was in before issuing the
command.
If the Set To Idle command was not issued, then the device is placed in default mod-
e.Command has no parameters. Device responds with ACK if stream successfully
enabled.
Field Format
Field Length
Field
Descriptor
Field Data
Command
0x02
0x06
N/A
Reply:
ACK/ NACK
0x04
0xF1
U8 - echo the command byte
U8 - error code (0: ACK, non-zero: NACK)
Example
MIP Packet Header
Command/Reply Fields
Checksum
Sync1
Sync2
Desc.
Set
Payload
Length
Field
Length
Field
Desc.
Field Data
MSB
LSB
Command:
Resume
0x75
0x65
0x01
0x02
0x02
0x06
0xE5
0xCB
Reply:
ACK/NACK
0x75
0x65
0x01
0x04
0x04
0xF1
Command echo: 0x01
Error code: 0x00
0xDA
0x74
Copy-Paste version of the command: “7565 0102 0206 E5CB”
4.1.7
Get Extended Device Descriptor Sets (0x01, 0x07)
Description
Get the extended set of descriptors that this device supports (descriptors in addition to the
set returned by the
command)
Reply has two fields: “ACK/NACK” and “Descriptors”. The “Descriptors” field is an array
of 16 bit values. The MSB specifies the descriptor set and the LSB specifies the
descriptor.
Notes
The
command is present on all devices supporting the
MIP protocol. Extended descriptors are only supported on some devices. You may check
for extended descriptors by searching for the 0x0107 descriptor in the list returned by the
command.
Field Format
Field Length
Field
Descriptor
Field Data
Command
0x02
0x07
N/A
Reply Field 1:
ACK/ NACK
0x04
0xF1
U8 - echo the command byte
U8 - error code (0: ACK, non-zero: NACK)
40