6
5
Menu Diagram
Changing the Pump Head
The pump head is mounted on drive before the pump leaves the factory. Follow
below procedure for changing another pump head.
Loose the two M4 screws which connect the pump head and the drive.
Dismantle the pump head slightly.
Inser t the flat end of the pump head's shaft to the slot of drive's coupling.
Make the location hole of the pump head match the location pin of the drive.
Inser t the two mounting screws into the mounting holes of the pump head.
Then tighten the mounting screws to connecting hole of drive. (For more
information, please refer to pump head's operation manual)
Turn off the power supply before changing the pump head.
1.
2.
3.
VOL
：
0.25mL
Copy
：
991
Running Inter face
1.System Setting
2.Control Mode
3.Disp Setting
4.Calibration
1. Pump head
&
Tube
YZ1515 ID 0.80
2.Ext Cont.
：
ON
3.Address
：
1
4.Footswitch
：
G
5.Back rpm
：
1
.
2
"
Flowrate
Dispensing
Disp Vol
:
2.02mL
Copy No.
：
10
Flow
:
2.043mL/min
Pause rpm
：
1.0
"
Flowrate
Dispensing
1.System Setting
2.Control Mode
3.Disp Setting
4.Calibration
YZ1515 ID 0.80
YZ1515
YZ2515
Select
Tubing ID
0.80 1.60 2.40
Ext Control
：
ON
OFF
Pump Address
：
1
1.System Setting
2.Control Mode
1. Pump head
&
Tube
1.System Setting
2.Control Mode
2.Ext Cont.
：
ON
3.Address
：
1
1.System Setting
2.Control Mode
2.Ext Cont.
：
ON
3.Address
：
1
System Setting:
All the setting can not be done when pump is running.
Pump head and tubing setting
Press the
Knob
to highlight Pump Head & Tube line, press
Knob
again to enter
pump head selection inter face, turn
Knob
to select the pump head, press the
Knob
for confirmation and enter tubing selection inter face, turn
Knob
to select
the tubing, press
Knob
for confirmation and return to pump head selection
inter face. Press
Exit Key
to return to previous menu.
External Control setting
Set the pump to enable the external control or not.
On: Enable external control (0 - 5 V, 0 - 10 V, 4 - 20 mA, 0 - 10 KHz)
Off: Disable
external control
Set the external control
Press and turn
Knob
to highlight the external control line. Press
Knob
to enter
next inter face, turn
Knob
to select On or Off, press
Knob
for confirmation. Press
Exit Key
to return to previous menu.
Press and turn
Knob
Press and turn
Knob
Address setting:
When control computer controls many pumps through RS485 inter face, it must
identify each pump's I.D. This pump I.D. should be unique. It's the identification
of this pump. Maximum 30 pieces WT600-1F can be controlled through RS485
at the same time.
Setting the address
Press and turn
Knob
to
highlight the address line. Press
Knob
again to enter next
inter face, turn
Knob
to select Pump I.D. number, press
Knob
for confirmation.
Press
Exit Key
to return to previous menu.
WT600-1F OPERATING MANUAL
WT600-1F OPERATING MANUAL
