USER MANUAL SMARTneo //
PAGE 6
2 SAFETY
2.1 GENERAL SAFETY REGULATIONS AND
OBLIAGTIONS
Generally, the following safety regulations and obligations apply to handling the product:
• The product must be operated only in perfect and clean state.
• It is prohibited to remove, change, bridge or circumvent any protection, safety or monitoring
equipment.
• It is prohibited to convert or change the product without the written release of LOGICDATA.
• In case of malfunctions or damage, the product must be replaced immediately.
• Repairs are prohibited. Defective products must be replaced as a whole..
• Hardware replacements or changes to the system configuration are permitted only in non-energi
zed state.
• Only qualified persons may carry out work on the system
• The national employee protective conditions as well as national safety and accident prevention
regulations apply to system operation.
2.2 RESIDUAL HAZARDS
Even with maximum diligence during the design and construction of the components and taking into
consideration all safety-relevant issues, there can be residual hazards which were evaluated using via
risk assessment.
WARNING
Danger of electric shock
Never open the motor control unit.
There is a danger of electrical shock
.
DANGER
Danger due to incorrect mains voltage
The motor control must be operated only with
mains voltage and the frequency ranges marked on the
rating plate of the mains adapter must not be exceeded.
There can be electrical hazards otherwise.
DANGER
Disconnect the power supply
Disconnect the power supply before removing or connecting any
components. There can be electrical hazards otherwise.
