USER MANUAL SMARTneo //
PAGE 25
10.3 CONTAINER STOP AND SHELF STOP POSITIONS
These two features can be used to limit the travel range of the table (if e.g. a container is below the table).
A container stop position can be set in the lower half of the travel range, a shelf stop position in the upper
half. If a container stop position is set, then this is used as the new bottom end position, a shelf stop position
is equivalent to a new upper end position of the travel range. Proceed as follows to save a container stop /
shelf stop position:
Put the table top in the position that you want to use as new container stop / shelf stop
position. Use the buttons
Table top down
or T
able top up
until the required position is
reached.
SAVE
Press the
memory button
for 10 seconds. The control clicks
twice
when the position is saved.
or
&
simultaneously
With hand control equipped only with up and down button, the function can be
carried out by pressing both the up and the down button simultaneously for 10 seconds.
NOTICE
A container stop position can be saved only in the lower half of
the travel range and a shelf stop position only in the upper half of
the travel range.
These steps must be carried out separately for a container stop
position and for a shelf stop position.