DMUI-EASY2MOVE - OPERATING MANUAL // PAGE 17
8 SYSTEM INFORMATION
When a DMUI-EASY2move Handset is installed alongside the DYNAMIC MOTION system, system informa-
tion is communicated via flashes of the LED Signal Light. Possible signals are as follows:
Signal
Message
Required Actions
No Light
System operating normally
Operate the DM System as normal.
System not connected
properly
See the DM System Manual for connection
instructions.
White Light On
System is in Motion
The system is moving. Keep away from moving
parts and ensure the table is in full vision.
Red Light Blinking
System Error Warning
Release all Keys and wait for 5 seconds. Then,
try to repeat the action again.
Disconnect the DM System from the Power Unit.
(If a Power Hub is used) Disconnect the Power
Hub from the Mains.
Check the Power Unit for overheating. Let cool
if necessary.
Check all cable connections and reconnect the
system.
If problem persists:
Perform a Position Reset Procedure (see System
Manual).
Contact LOGICDATA
Green Light Blinking
System Start-up
Wait until the LED has stopped blinking to
continue.
Do not press any buttons.
Reset in Progress
Duty Cycle Exceeded
Collision Detected (ISP)
Remove the obstruction from the Table System.
Remove unnecessary loads from the Table Top
Operate the DM System as normal.
NOTICE
Do not operate the DYNAMIC MOTION system if problems persist. Contact LOGICDATA
for further information.
