DMUI-EASY2MOVE - OPERATING MANUAL // PAGE 18
9 ADDITIONAL INFORMATION
9.1 SOFTWARE-DEPENDENT FUNCTIONS
A full list of Software-Dependent Functions can be found in the DYNAMIC MOTION system manual.
9.2 DISASSEMBLY
To disassemble the DMUI-EASY2move, disconnect the DYNAMIC MOTION system from the mains. Then,
follow the assembly instructions in reverse order.
9.3 MAINTENANCE
The DMUI-EASY2move Handset is maintenance-free.
WARNING Risk of death or serious injury through electric shocks and other hazards
Using a Handset alongside unauthorized spare or accessory parts may lead to death or
serious injury through electric shocks and other hazards.
• Only use accessory parts produced or approved by LOGICDATA
• Only use replacement parts produced or approved by LOGICDATA
• Only allow Skilled Persons to perform repairs or install accessory parts
• Contact customer services immediately if the system malfunctions
The use of unauthorized spare or accessory parts may cause system damage. Warranty
claims are void in this scenario.
9.3.1 CLEANING
1. Disconnect the DYNAMIC MOTION system from the mains.
2. Wait 30 seconds for residual voltage to dissipate.
3. Wipe the Handset with a dry or slightly damp soft cloth. Never immerse the Handset in liquid.
4. Wait for the Handset to dry completely.
5. Reconnect the DYNAMIC MOTION system
9.3.2 REPLACING A HANDSET
1. Disconnect the DYNAMIC MOTION system from the Mains.
2. Disconnect the Handset from the Power Hub.
3. Remove the Handset from the Table Top.
4. Mount the new Handset onto the Table Top.
5. Plug the Handset back into the Power Hub.
6. Reconnect the DYNAMIC MOTION system to the Mains.
9.4 TROUBLESHOOTING
Usually, malfunctions occur when Handsets are pressed while calibrating. If the Handset fails to function,
you will need to restart the system. To do this:
1. Unplug the Handset from the Power Hub.
2. Plug the Handset back into Power Hub.
3. After a few seconds the Handset is ready for operation.
A list of common problems and their solutions can be found in the DYNAMIC MOTION system manual.
9.5 DISPOSAL
All products in the DM System are subject to the WEEE Directive 2012/19/EU.
• Dispose of all components separately from household waste. Use designated collection
points or disposal companies authorized for this purpose
