57
english
Loewe bild | Extended operating instructions
Connecting the TV set
Before making any connections to an external devices, make sure both TV set and device are disconnected from power.
Most TV connectors are hidden under the back cover. To access these connectors, you must remove the back cover by pulling the top and bottom
parts away as shown in the illustration. Both parts are held in place only by magnets, so there is no need to use any tools or remove screws.
When connecting external devices to these internal connectors, first connect the cable to the connector on the TV set. Then route the cable out of
the TV using the built-in cable management system, and then route the cable through the neck of the stand (in case you use provided Table stand
solution).
When you have finished connecting external devices to the TV, replace the back cover.
Connecting the soundbar klang bar i
bild i set variants are provided with a klang bar i soundbar. Alternatively, you can buy a klang bar i as optional component for your standard bild i TV.
klang bar i soundbar is provided in a separate carton box, where you will also find detailed assembly instructions. Follow these instructions to install
the soundbar on the TV.
Connecting antennas
Terrestrial / cable analogue /
DVB-T/T2/C HD antenna:
Plug the cable of antenna, cable TV system or room antenna into the ANT TV socket.
If you want to use analogue cables/DVB-C connection and a DVB-T antenna together, use an external antenna switch (available from your dealer).
Satellite antenna DVB-S/S2 HD:
Connect a connecting cable from the from the LNB to the ANT SAT socket of the TV set.
ANT
TV
ANT
SAT
R TV
Cable
analogue /
DVB-C
S
-
B
V
D
T
-
B
V
D
Setup
