If the dispense quantity is achieved too slowly, increase the dispense pressure and
check the dispense quantity again.
Repeat this sequence until the desired dispense quantity is achieved in an
acceptable amount of time.
5.2.3 Programs
This mode of operation is used for precise repeatable dispensing.
Press the
button until the LED above PROGRAM is lit.
Press the
button to setup the program number. The number on the display
will flash. Press the
button and the
button to change numbers, press the
button to move the cursor.
Press the
button to save the data.
You can set a program number to record dispense and interval time in Timer and
Cycle mode. The program number can be 00-39.
For detailed operation please check chapters 5.2.4 and 5.2.5.
5.2.4 Timer mode
Select a program number following the setup in section 5.2.3.
Press the
button until the LED above TIMER is lit.
Press the
button, to set the the dispense time, followed by the
button
and the
button to change numbers, and the
button to move the cursor.
Press the
button to save the data.
Press the
button or foot switch to dispense.
