17
5.2.2.2
Cont
inuous Mode
This mode of operation is used for wettings of varying lengths or for the application of beads.
●
With the pressure regulator
9
, set the
dispensing pressure to 0.50 bar (approx. 7 psi).
An error message “
P
Pr
re
es
ss
s.
.
0
0.
.8
83
3
N
NO
OK
K
” with
beeping is possible. The value
0
0.
.8
83
3
[bar/psi]
is only an example for the indicated dispensing
pressure (see Chapter 7).
●
Press button
to store the dispensing
pressure setting as the comparison value for
automatic pressure monitoring.
The error message with beeping is eliminated.
●
Press button
. The lighting of the LED in
button indicates
cont
inuous mode. The
indication of the dispensing time in the digital
display is set to 0.00 s and blinks.
●
Press button
(or the Foot Switch
20
) until the
dispensed quantity is roughly achieved.
When the dispense quantity is achieved too slowly:
●
Increase the dispensing pressure and store. Check the dispense quantity again.
Repeat this sequence until the desired dispense quantity is roughly achieved.
☞
– Switch back to time controlled mode
without storage
of the dispensing time by repeated pressing
of button
. The LED in button
extinguishes. In the digital display, the dispensing time
previously stored for the time controlled mode reappears.
– Switch back to time controlled mode
with storage
of the dispensing time by pressing
button
. The LED in button
extinguishes. The indicated dispensing time is stored and the
display stops blinking.
If the desired dispense quantity is not achieved:
●
With a larger (or smaller) dispensing needle
16
, repeat the steps of Section 5.2.2.2.
CONT
CONT
CONT
START
CONT
CONT
Dispensing
5
R
START
CONT
bar
psi
97006
CONT
bar
psi
START
CONT
bar
psi
START
CONT
bar
psi
START
