Lockdoor ZTGD1000, Инструкция по установке и эксплуатации

Страница: 27 / 42

27
7, Adjustments (Continued)
7-2, Symbols Introduction
State of Lamp State of Button
8 LED lamps and 3 buttons are used for programming:
“P” Enters into and selects programming menus.
“+” “-” Multi-function; move door during programming and advance through menus.
7-3, Setting the UP(Open) Travel Limit
Step1, Plug your plug in, LED3 turns on
Step2, Press and release the "P" button, LED2 will begin flashing.
Step3, Press the "+" and hold it to begin opening the garage door. When the garage
door is fully opened, release the
“+” button. If you have gone too far press and release
the
“-” to move the door down slightly. You may jog “+” or “-” buttons. Stop the
shuttle/carriage short of the opener powerhead. It is important for the red cord to be
clear of the powerhead to allow for manual door operation.