Lockdoor ZTGD1000, Инструкция по установке и эксплуатации

Страница: 31 / 42

31
8, Programming
NOTE: Before you begin programming, check to make sure there are no
objects in the garage door opener.
8-1, Programming Remotes and Wireless Wall Mounted
Remote(Optional on some models)
NOTE: THE REMOTE CONTROLS AND WIRELESS WALL MOUNTED
REMOTE INCLUDED WITH THIS OPENER HAVE BEEN
PRE-PROGRAMMED AT THE FACTORY.
The following instructions are for remote control transmitters and wireless wall mounted
remote purchased separately in addition to those provided with this opener, but also can
be used for remote(s) that require re-programming.
Step1, Press and hold the
“P” button, till LED7 starts flash
Step2, Press and release the
“+” button, all LEDs turn off except LED7
Step3, Quickly press and release the remote button of your choice two times, all LEDs
turn on and LED7 starts flashing, indicating you have successfully programmed your
remote. Press and release
“P” button to save
To program the same remote for other garage door openers, repeat the steps above using
one of the other remaining remote buttons.
BASIC PROGRAMMING IS COMPLETE AND YOUR GARAGE DOOR
OPENER IS READY TO USE.