Lockdoor ZTGD1000, Инструкция по установке и эксплуатации

Страница: 3 / 42

3
1, User Information
1-1,Safety Notes:
Garage doors are the largest automated moving object in most homes. Care needs to be
taken when using this system. Since moving objects, springs under tension, and electric
motors can cause injuries, your safety and the safety of others depend on you reading the
information in this manual.
1-2,Important Safety Instructions:
READ AND FOLLOW ALL SAFETY, INSTALLATION AND OPERSTION INSTRUCTIONS.
- Only operate the garage door when in full view to ensure people remain away from the
door while door is moving
- Keep all controls away from children and do not allow them to play with the door
opener
- Regularly check the door and when required have it repaired or serviced.
- Safety beam must be installed to close door.
CAUTION: This garage door opener is designed to operate only at 110V-120V,
60HZ to avoid malfunction and damage.
1-3, Important Safety Requirements and Regulations
FAILURE TO COMPLY WITH THESE SAFETY REQUIREMENT AND LOCAL
SAFETY REGULATIONS MAY RESULT IN SERIOUS INJURY, DEATH OR DAMAGE
TO PROPERTY.
PLEASE READ CAREFULLY AND ENSURE THAT ALL SAFETY RECOMMENDATIONS
and REQUIREMENTS ARE CONSIDERED ADHERED TO.
- The appliance is not to be used by children or persons with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction.
- Children being supervised not to play with the appliance.
- WARNING: Important safety instructions. It is important for the safety of persons to
follow all instructions. Save these instructions.
- Frequently examine the installation, in particular check cables, springs and mountings
for signs of wear, damage or imbalance. Do not use if repair or adjustment is needed
since a fault in the installation or an incorrectly balanced door may cause injury.
- Each month check that the drive reverses when the contacts a 40mm high object
placed on the floor. Adjust if necessary and recheck since an incorrect adjustment
may present a hazard.
- Before installing the drive, remove all unnecessary ropes or chains and disable any
equipment, such as locks, not needed for powered operation.
- Before installing the drive, check that the door is in good mechanical condition,
correctly balanced and open and closes properly.
- Install the actuating member for the manual release at a height less than 1.8m.
- Install any fixed control at a height of at least 1.5m and within sight of the door but