Lockdoor ZTGD1000, Инструкция по установке и эксплуатации

Страница: 33 / 42

33
8, Programming (Continued)
8-3-3, Method of use
The use of the keypad is based on "combinations", i.e. numbers of from 1 to 9 digits that
the user is required to key in by means of the keys. Once the combination has been
Entered the user then presses confirm key

or

to transmit the activation command to,
respectively.
-receiver channel 1 if the user presses

-receiver channel 2 if the user presses

.
The command will be transmitted only when a valid combination has been entered - if an
incorrect combination has been entered the selector will emit an error, warning signal
when the confirm key is pressed . The combination entered must be exact, if, for
example ,the correct combination is 0422, the following attempts will be interpreted as
errors:422, 10422, 04222. Therefore, if the user inadvertently presses the wrong key
when entering a combination, combination key

or

should be pressed immediately to
generate the error tone , after which the correct combination can be entered starting from
the beginning again.
While entering the combination no more than 6 seconds can be allowed to elapse
between keystrokes, after which interval the combination must be re-entered starting from
the beginning.
The units are factory programmed with a standard combination to activate channel one
and a standard combination for channel two.
The factory set combinations are as follows:
1ª combination to transmit the code associated with the

key.
When the unit is used for the first time this combination is 11
2ª combination to transmit the code associated with the

key.
When the unit is used for the first time this combination is 22.