Lochinvar Amicus LAHP1202WW, Инструкции по установке, пусконаладке, эксплуатации и техническому обслуживанию

Страница: 52 / 58

52 | P a g e
Be sure to reset an alarm only after you have removed the cause of the fault; repeated reset may result in irrevocable
damage to the unit.
9. DIAGNOSIS AND TROUBLESHOOTING
F
AULT FINDING
All units are checked and tested at the factory before shipment, however, during operation an anomaly or failure can occur.
Code Alarm Description Cause Solution
ACF1 Configuration alarm
Wrong configuration of microprocessor
control system.
Contact the Lochinvar Limited.
ACF2 Configuration alarm
ACF3 Configuration alarm
ACF4 Configuration alarm
ACF5 Configuration alarm
ACF6 Configuration alarm
ACF7 Configuration alarm
ACF8 Configuration alarm
ACF9 Configuration alarm
AEE Eeprom alarm
Severe hardware damage in the
microprocessor control system.
Switch OFF the unit and, after few
second switch ON the unit; if the alarm
appears again contact the service.
AEFL User water flow switch alarm
Presence of air or dirtiness in the user
hydraulic system.
Bleed carefully the user hydraulic system or
check and clean the water strainer.
AEUn
Compressor unloading alarm (only
units with 2 compressors)
User water temperature is too high.
Wait until the user water temperature is
lower.
AHFL Domestic hot water flow switch alarm
Presence of air or dirtiness in the user
hydraulic system.
Bleed carefully the user hydraulic system or
check and clean the water strainer.
AP1
Alarm user inlet water temperature
sensor
Wrong electrical connection, Sensor
defect.
Check the electrical connection of the
sensor to the terminal board, if correct
call the service to replace the sensor.
AP10
Alarm safety domestic hot water
sensor
AP2
Alarm user outlet water temperature
sensor
AP3 Alarm pressure transducer
AP4
Alarm finned coil sensor / defrost
sensor
AP5
Alarm domestic hot water inlet tempe-
rature sensor
AP6
Alarm domestic hot water outlet
temperature sensor