LNS ECO LOAD, Инструкция по эксплуатации

Страница: 48 / 67

44
ECO LOAD
8. PROGRAMMING
8.1 Function switches
The function switches are set by the technician and should, as a matter of principle, not be
changed !
However, should this prove necessary :
C
Turn off the machine at the master switch
C
Open the electrical housing
C
Set the parameters as indicated in the table below.
C
Close the electrical housing
C
Turn on the feeder.
Setting the machine :
Function switch configurations
Switch No. Function Switch position
1 - 2 Select program OFF / OFF = START / STOP
ON / OFF = with M-Code
OFF / ON = single-bar cycle
ON / ON = test program
3 - 4 Signal block delete OFF / OFF = permanent signal
ON / OFF = double pulse
OFF / ON = double pulse
ON / ON = permanent signal
5 Chuck selection ON = If signal is "1" with Chuck closed
OFF = If signal is "1" with Chuck open