LNS ECO LOAD, Инструкция по эксплуатации

Страница: 35 / 67

31
ECO LOAD
6. START-UP PROCEDURE
6.1 General comments
The bar must be pushed right into the spindle. There is no mechanical connection between the
feeder and the lathe. The Pusher-bar must pass through the clamping system to ensure that the
bar remnant is ejected.
6.2 Adjusting the machine
6.2.1 Setting the diameter
The diameter is adjusted by means of the hand-wheel II while checking on the scale I :
Procedure :
• Press the button to switch to
manual mode then place the button
in the home position.
C
Release the locking handles III
C
Set the new diameter using the
scale I
C
Secure the locking handles III
Check setting and fine-tune, if necessary.
C
Press the button.
C
Place bar stock in the magazine
C
Move the bar stock forward and
check that it enters the lathe spindle
properly
C
Remove the bar stock from the
magazine.
C
If necessary, readjust by pressing the button and repeat the above procedure.
ATTENTION : The bar stock must be removed from the feeder before pressing the
button.