LNS ECO LOAD, Инструкция по эксплуатации

Страница: 42 / 67

38
ECO LOAD
7.3 Functions F1 - F8
(All measurements given are in millimeters)
F1 : Software version including date issued
(press for 2 seconds)
F2 : Pusher-bar position limit
The pusher-bar tends to flex as it leaves
the device. As a result, in a given
position, it might touch the inside of the
spindle. Parameter F2 serves to limit the
position of the pusher-bar when the
spindle is rotating.
Each time the chuck closes at the beginning of the bar, the pusher-bar withdraws by the
amount entered under parameter F4 in order that it not be in contact with the rotating bar.
After a given number of workpieces, the pusher-bar will withdraw to the position defined in
parameter F2 each time the chuck closes.
F3 : Workpiece length
The workpiece length includes the length of the piece to be
machined and the thickness of the cut-off tool.
At each start-up, if the length of the workpieces to be machined
changes, this parameter will have to be adapted.
F4 : Pusher-bar return stroke
Each time the chuck closes, the pusher-bar
returns by the amount set in parameter F4
in order that it does not come into contact
with the rotating bar.
Enter a setting of over 1 mm.
The pneumatic cylinder will always
withdraw to a distance greater than the distance set.