LNS ECO LOAD, Инструкция по эксплуатации

Страница: 39 / 67

35
ECO LOAD
6.6 Pusher selection
The diameter of the pusher-bar must always be adapted to that of the bar stock..
Pusher Bar stocks
# 6 mm (0.236") < 16mm (0.63")
# 12 mm (0.472") 16 mm - 25 mm (0.63"-1")
# 19 mm (0.75") > 25 mm (1")
a) Replacing the pusher
1. Loosen screw I to disengage
bushing II
2. Move the bushing II backward
3. Pull pin III left side to disengage
the pusher IV
4. Loosen screw V, remove the
pusher IV from its support VI.
Take care to the spring VII
located inside of the support
5. Pull the pusher IV forward
6. Extract the pusher
Insert the new pusher by
reversing the above procedure
Store the pusher that has just
been removed into the cover
(whence you took the new
pusher-bar)
b) Setting the pusher-bar pressure
(force exerted)
Recommended settings :
Diameter Pressure
up to 10 mm (0.4") 3 bar (45 Psi)
from 11 to 30 mm (0.43" - 1.18") 3 - 4 bar (45 - 60 Psi)
above 31 mm (1.22") 4 - 6 bar (60 - 80 Psi)