Changing the Sensor IP Address
Changing the sensor IP address will disconnect the sensor from the smart
display. DO NOT modify the sensor IP address unless you are also modifying the
Smart Display settings which correspond with this address.
1. With a sensor selected, press the
Set IP Address
button. A new window will appear.
2. Enter the desired IP Address, mask and gateway.
3. Press the
Set IP Address
button
4. Wait up to 1 minute for the utility to reconnect to the sensor. The connected
indicator will be orange for this time.
5. After the sensor reconnects, you will need to change the IP address of the sensor in
the smart display. The device is configured to communicate with the sensor using
the default IP address. If the sensor address is changed, the Smart Display external
IP Address settings needs to be updated to match.
6. Press and hold the top left corner of the smart display, above the word LENGTH for
3 seconds until a menu pops up
Gocator Legal for Trade User Manual
26