LMI Gocator 2000 Family, Руководство пользователя

Страница: 36 / 194

Setup • 36 Gocator 2000 Family
Saving and Loading Settings
When you change sensor settings using the Gocator user interface, some changes are saved
automatically, while other changes are temporary until you take action to save them. The following table
summarizes the types of information that can be saved in a sensor.
Saved Information
Information Type Behavior
Network Address Network address changes are saved when you click the Save button in Main Panel
on the Connection Page. The sensor must be reset before changes take effect.
Configuration Most of the settings that can be changed in the Gocator’s user interface, such as
those shown on Setup, Measurement, and Output pages, are temporary until saved
in a configuration file. Each sensor can have multiple configuration files. If there is
a configuration file that is designated as the default , it will be loaded automatically
when the sensor is reset.
Calibration Calibration files, described in the Calibration section (page 58) in this chapter are
saved automatically at the end of the calibration procedure. If a sensor contains a
calibration file, it will automatically be loaded when the sensor is reset.
Profile Templates Profile templates , described in the Measurement section (page 62) later in this
guide, are temporary until saved. Each sensor can have multiple profile template
files. If there is a template file that is designated as the default , it will be loaded
automatically when the sensor is reset.
Each sensor can have, at most, one network address and one calibration record. But sensors can
contain many configuration and template files – the number of files is limited only by the sensor’s flash
storage capacity.
Because configuration and profile template files are often used together to perform a particular task, the
Gocator’s user interface provides toolbar commands to load and save these files as a group.
FILE NAME SAVE
LOAD
DELETE
The File name drop down list shows the list of configurations stored in the sensor. The configuration
that is currently loaded will be listed at the top. The name will be marked with an asterisk if the live
configuration is different from the loaded configuration.
To save a new pair of configuration and template files:
1
Select [New] in the File Name drop list.
2 Enter a name for the file pair.
3
Press the Enter Key or click the Save Button.
The files will be saved to flash memory using the name provided. The saved files will be set as the defaults
to be loaded automatically when the sensor is reset.