LMI Gocator 2000 Family, Руководство пользователя

Страница: 31 / 194

Getting Started • 31 Gocator 2000 Family
Assigning a Buddy
Gocator sensors can control an additional sensor called a Buddy . After assigning a Buddy, the Main
sensor assumes control of the Buddy sensor. All subsequent configuration steps for both sensors can be
performed through the Main sensor’s interface.
Main and Buddy sensors must be assigned unique addresses before they can be used on the same network.
Before proceeding, connect the Main and Buddy sensors one at a time (to avoid an address conflict) and use
the steps in the previous section to assign each sensor a unique address.
To assign a Buddy sensor:
1 Log in to the Main Sensor.
2 Go to Connection Page > Buddy Panel.
The serial numbers of potential Buddy sensors
are listed in the Buddy Panel.
3 Select a Buddy sensor.
4
Click the Assign Button.
The Buddy sensor will be assigned to the Main
sensor and its status will be updated in the
Buddy Panel.
The firmware on Main and Buddy sensors must be the same for Buddy assignment to be successful. If the
firmware is different, connect the Main and Buddy sensor one at a time and use the steps in the section on
Updating Firmware (page 32).