10
0800 422 274
NZ
Getting Started: Installation (Cont.)
• The drain hose and drain pump filter are located at the back of the machine, as
illustrated below, left.
• Pinching the two bands of the clamp on the drain hose, connect it to the drain hose
connection at the back of the washer, as illustrated below, right.
• Pull the drain hose upward and affix it to the hose clip at the back of the washer.
• When the washer is in use, put the drain hose into a drain spout (or into a sink/tub),
as illustrated on the opposite page.
Installing the drain hose
CAUTION!
When tightening the clamping nut, take care not to damage the water
inlet valve joint. Apply force evenly and do not twist the water inlet valve.
CAUTION!
Use only the new (supplied) hoses with your new appliance. Do not
use a hose from an existing machine, or one that has been used previously.
CAUTION!
In the event that the hoses are too short for your set-up, please seek
advice from your local washing machine store to purchase a longer hose.
Drain pump with
lint filter
Drain hose
connection
