17
GB/IE
A new LED insert can be obtained from the specified
service address.
To replace the LED insert, proceed as
follows:
Use the LED installation key
17
to remove the
cap
18
on the tap spout
23
.
Remove the silicone seal
19
and then – using
the LED installation key
17
again – remove the
LED insert
20
from the aerator housing
21
.
Install the new LED insert and the silicone seal
in the opposite way to disassembly.
Replacing the cartridge
Cartridges are wearing parts that must be replaced
at regular intervals depending on the lime content
and contamination levels of the water. If the tap lever
becomes stiff to operate, this can be a sign that the
cartridge must be replaced. Replacement cartridges
can be obtained directly at the specified service point.
Proceed as follows:
Carefully remove the hot / cold plaque
1
from
the tap lever
3
with the help of a small flat-tip
screwdriver.
Loosen the underlying Allen grub screw
2
using
the Allen key
9
by turning it anti-clockwise for
a few turns. Do not unscrew the Allen grub screw
2
completely, only loosen it until the tap lever
3
can be easily removed.
Remove the tap lever
3
.
Unscrew the cartridge covering ring
4
by
hand in an anti-clockwise direction.
Unscrew the locknut
5
using fitting or syphon
pliers in an anti-clockwise direction.
Pull the cartridge
6
out of the cartridge base
7
.
Carefully insert the new cartridge into the
cartridge base
7
.
Make sure that the seals under the cartridge
are positioned correctly and that the leads are
inserted into the openings provided.
Screw the locknut
5
tight using fitting or
syphon pliers.
Screw in the cartridge covering ring
4
tightly
by hand.
Insert the tap lever
3
into the cartridge.
Fix the tap lever
3
by tightening the Allen grub
screw
2
in a clockwise direction using the Allen
key
9
.
Insert the hot/cold plaque
1
into the tap lever
3
. Pay attention to the correct orientation:
left = red (hot water)
right = blue (cold water).
Note:
If you tighten the cartridge safety ring
too firmly, the tap lever
3
can be very difficult
to move. In this case, slightly loosen the car-
tridge safety ring again.
Disposal
The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
To help protect the environment, please
dispose of the product properly when it
has reached the end of its useful life and
not in the household waste. Information
on collection points and their opening
hours can be obtained from your local
authority.
Information
Checking if tap water
is drinkable
Ask your local authorities whether the water in your
town / municipality is drinkable.
In general the following recommendations apply
for the drinking water quality of tap water:
Do not use any stagnant water to prepare dishes
or drinks, and in particular to feed infants.
Failure to observe these instructions may have
negative health effects. You can tell when water is
fresh because it comes out of the tap noticeably
colder than stagnant water.
