14 GB/IE
List of pictograms used
Read the assembly and
operating instructions!
Danger to life and risk of accidents
for infants and children!
Observe the warnings and
safety instructions!
Warning - risk of electric shock!
Danger to life!
There is a danger of
severe or fatal injuries!
21
PAP
Dispose of the packaging and device
in an environmentally friendly manner!
LED kitchen tap
Introduction
Congratulations on the purchase of your
new product. You have chosen a high-
quality product. The assembly and oper-
ating instructions are part of this product. Please read
these assembly and operating instructions carefully
before use and observe all the information. These
instructions contain important information about in-
stallation, settings and care. Therefore we ask that
you retain these assembly and operating instructions
and pass them on to any future owner.
Intended use
The product is exclusively designed for the regulation
of hot and cold water flow and for installation on
sink units. This product is a water-saving tap. The
product is suitable for use with all pressuretight hot
water systems such as central heating, instantaneous
water heaters, pressurised boilers, etc. The product
is not suitable for low pressure water heaters such
as wood or coal water heaters, oil or gas hot water
heaters or open electrical storage heaters. If in doubt,
consult a plumber or heating specialist. Any use other
than those stated above, or any product modification
is prohibited and can result in injuries and / or product
damage. Furthermore, improper use may result in
life-threatening risks and injuries. The tap is only for
private use and is not intended for medical or com-
mercial use. The manufacturer is not liable for dam-
ages due to improper use.
Parts description
1
Warm / cold plaque*
2
Hexagon socket grub screw*
3
Tap lever*
4
Cartridge covering*
5
Cartridge safety device*
6
Cartridge*
7
Cartridge base*
8
Flexible connecting hoses
9
Hex key
10
Fastening nut
11
Transparent washer
12
Silicone sealing ring
13
Plastic triangle
14
Tap thread
15
Base ring seal
16
Base ring*
17
LED installation key
18
Cap*
19
Silicone seal*
20
LED insert*
21
Aerator housing*
22
Silicone seal*
23
Tap spout*
24
Tap body*
*pre-assembled
Technical data
Connections: G⅜
Minimum flow
pressure:
1.5 bar
